Installation Instructions
1. Install the Filters and Membrane Cartridge
• Wearing sterile gloves, remove the two filters and membrane
cartridge from the sterile packaging and place them in the appro-
priate housings (see figure 2).
2. Mount the System
• Use screws (not supplied) to secure the mounting bracket
(supplied) to the desired location.
3. Install the Faucet (Not Supplied)
• Select a location for the faucet (not supplied) to be mounted.
• Drill a hole according to the manufacturer’s recommendations.
Once the hole has been drilled, mount the faucet.
• Use 3/8 inch tubing (not supplied) to connect the faucet to the
system outlet (see figure 2).
4. Install the Inlet Shut Off Valve (Not Supplied)
• Turn off the cold water supply and open the cold water faucet to
relieve any line pressure.
• Install an inlet shut off valve (not supplied) between the existing
shut off valve and the kitchen faucet, in a way that conforms to
state and local plumbing codes.
• Use 3/8 inch tubing (not supplied) to connect the inlet shut off
valve to the system inlet (see figure 2).
5. Install the Storage Tank
• Select a location for the storage tank. The storage tank can be
installed vertically or horizontally.
• Verify that the o-ring on the storage tank is in place.
• Install the shut off valve (supplied) onto the storage tank (see
figure 2). The shut off valve must be in the open position.
• Use the 3/8 inch x 4 foot tubing (supplied) to connect the storage
tank shut off valve to the tank port on the control head (see
figure 2). Additional tubing may be required
6. Connect the Drain Outlet
• Use 1/4 inch tubing (not supplied) to connect the drain outlet to
the appropriate drain connection (see figure 2).
7. Secure the Connections
• Attach the red locking clips (supplied) to the connection fittings.
5
Helpful Tip: Be careful not to contaminate the
filters and membrane cartridge by touching non-
sterile objects.
Helpful Tip: The proper drill bit should be selected
according to the type of material at the desired
installation location.
INLET
OUTLET
DRAIN OUTLET
STORAGE TANK
TANK PORT
SHUT OFF VALVE
PRE-FILTER
MEMBRANE
POST FILTER
Helpful Tip: If the desired installation location is
in the basement, the storage tank can be
mounted in between the floor joists. The closer
the storage tank is to the faucet, the greater the
flow of water.
The storage tank can be installed vertically or
horizontally.
Helpful Tip: To secure the connection, press the
tubing in firmly.
!
Important Note: The drain connection must
conform to state and local plumbing codes.
If the system is mounted under a kitchen sink, an
air gap faucet will be required. If the system is
mounted in a different location, a non-air gap
faucet will be required, along with a separate air
gap device on the drain line (see figures below--
Air Gap-floor drain, Air Gap-Mr.Drain).
Figure 2
1/2" DRAIN LINE
FLOOR DRAIN
AIR GAP
Helpful Tip: Additional tubing may be required.
!
Important Note: The inlet shut off valve must
have a 3/8 inch connection.
AIR GAP - floor drain
AIR GAP - Mr. Drain
