58"
1"
5 3/8"
5 3/8"
THIS PENTHOUSE CORNER
POST (6321) LINES UP WITH
CLUBHOUSE CENTER POST
(6138) (6313)
6321
4069
6320
6320
4069
6320
3181
3181
H1
H97
H1
H97
H1
H97
H1
H97
THIS END OF PENTHOUSE
AWAY FROM SET
COUNTER BORED
HOLES FACING
OUT
A
1 1/4"
INSET A
6320
4069
*NOTE: Pre-drill holes for all Lag Bolts using the appropriate drill bit.
*NOTE: For ease of assembly, construct Penthouse on a flat, level surface.
1. Lay Penthouse Corner Posts
(6320) (6321)
on ground
58"
apart, with counter bored holes facing
up. Measure down
1"
from top of Penthouse Corner Posts
(6320) (6321)
and attach Penthouse
Side Boards
(4069)
using 1/4" Hardware
(H1) (H97)
. Offset holes must be oriented as shown in
Inset A.
*NOTE: Penthouse Corner Post (6321) must be installed on the side of the Penthouse that
will line up with the Clubhouse Center Post (6138) (6313), and on the end of the
Penthouse that will face towards the set.
*NOTE: Only install one Penthouse Side Board (3181) if assembling Penthouse with Spiral
Slide.
2. Measure up
5 3/8"
up from bottom of Penthouse Corner Posts
(6320) (6321)
and attach Penthouse
Side Boards
(3181)
using 1/4" Hardware
(H1) (H97)
.
THIS END OF
PENTHOUSE
TOWARDS SET
6321
96
Step 55
Penthouse Assembly