Continued on next page:
*ATTENTION: Commercial units are pre-engineered for construction with the Wood Roof
option but can be constructed without. Complete the required part
modifications, per Step 24, prior to assembly if not installing Wood Roof Option.
*NOTE: If assembling Pod C without the Wood Roof option skip to Step 24.
1. Attach Commercial Ground Runners
(6796)
and Main Beams
(7690)
to 60" DH Corner Uprights
(6803)
and 60" DH Center Uprights
(6791)
using 3/4" Hardware
(H5)
and 1/2" Hardware
(H4) (H12)
(H18) (H29) (H71)
. Do not fully tighten hardware at this time.
2. Center and attach Center Uprights
(6791)
to Main Beams
(7690)
using 3/8" Hardware
(H3) (H119)
.
3. Measure up
12 5/8"
on Corner Uprights
(6803)
(as shown in Inset A) and attach 6 Hole Facias
(4732)
using 3/8" Hardware
(H3)
(H116)
. 6 Hole Facias
(4732)
should have offset holes,
1 1/4"
from edge,
up (as shown in Inset B).
4. Square each wall assembly using a tape measure, level, and square.
5. Finish tightening Hardware from #1.
71
Step 23
Pod C Wall Support
Assembly
Содержание Commercial Design C
Страница 10: ...0 1 2 3 4 5 6 7 8 9 H37 H44 H52 H71 H75 H50 H74 H72 NOTE Thread length may vary from what is pictured 9...
Страница 29: ...28 NOTES...
Страница 71: ...70 NOTES...
Страница 83: ...82 NOTES...
