Rainbow Play Systems Commercial Design C, Руководство по сборке

Страница: 30 / 126

Continued on next page:
*ATTENTION: Commercial units are designed for construction with the Wood Roof option,
but can be constructed without. Complete the required part modifications, per
Steps 2 and 4, prior to assembly, if not installing Wood Roof Option.
*NOTE: If assembling Design A without the Wood Roof option, skip to Step 2.
*NOTE: In this step and all future steps, pre-drill 1/8" pilot holes for all 1/4" and 5/16" lag bolts
and 1/4" pilot holes for all 3/8" lag bolts.
1. Attach Commercial Ground Runners
(6796)
to ML Corner Uprights
(6799)
and ML Center Uprights
(6798) using 3/4" Hardware (H5) and 1/2" Hardware (H4) (H12) (H18) (H29) (H71) . Do not fully
tighten hardware at this time.
2. Measure up
12 5/8"
and
85"
on ML Corner Uprights
(6799)
(as shown in Inset A) and attach 6 Hole
Facias (4732) to ML Corner Uprights (6799) and ML Center Uprights (6798) using 3/8" Hardware
(H3) (H116)
. 6 Hole Facias
(4732)
should have offset holes farthest from edge up (as shown in
Details A & B).
3. Square each wall assembly using a tape measure, level, and square.
4. Finish tightening Hardware from #1.
29
Step 1
Pod A Wall Support Assembly