SA 25
SA 25
SA 25
SA 25
SA 25
Chapter 4
Use of the commands
© Raimondi S.p.a.
Via dei Tipografi, 11 - 41100 Modena (Italia)
Tel.: +39.059.280.888 - Fax: +39.059.282.808
www.raimondiutensili.it - e-mail: [email protected]
Use and Maintenance Manual
Page 23/44-4
DURING THE CUTTING OPERATION, COMPLY WITH THE
INSTRUCTIONS IN THE “OPERATOR POSITION” PARAGRAPH
VERIFY CLEAN WATER IS IN THE TANK, IN A QUANTITY SUCH THAT
THE PUMP IS COMPLETELY SUBMERGED - SEE PARAGRAPH “5.5
TANK CLEANING”. TURBID WATER CAN CAUSE MALFUNCTIONING
OR BREAKING OF THE PUMP
ACT ON THE SPECIFIC COCK
(D) TO SET THE CORRECT WATER
FLOW ON THE BLADE.
D
4.2 Diagonal cuts
Loosen the knob
(A)
and rotate the slider
(A)
so that the tile insertion is not hampered.
Loosen the wing nut
(C)
and adjust the swivelling square at 45°. Lean the tile against the tilted square. In order to make the
blade cutting line coincide with the desired cut, place the square
(D)
on the square-holder and adjust the 45° tilt. Keeping
the blade above the tile surface, make the trolley slide to check the correct positioning. Once the alignment is reached,
tighten the knob completely
(E)
and wing nut
(C).
In case of repetitive cuts, lock the slider
(B)
by means of the knob
(A).
IN CASES OF CUTS WITH INCLINATION DIFFERENT THAN 90° AND 45°, IT IS NECESSARY TO TRACE THE
CUTTING LINE TO BE CARRIED OUT ON THE TILE . WITH MOTOR SWITCHED OFF, PLACE THE TILE ON
THE WORK BENCH, MAKE THE MATERIAL SLIDE UNDER THE BLADE, BY CHECKING THE COINCIDENCE
OF THE CUTTING LINE WITH THE LINE PREVIOUSLY TRACED ON THE TILE. PUT THE SWIVELLING SQUARE
NEAR THE MATERIAL EDGE BY MAKING IT ADHERE AND LOCK IT BY TIGHTENING THE KNOBS (A) and (B).
BRING THE SLIDER INTO CONTACT AND ALSO TIGHTEN THE KNOB (C).
C
E
A
B
B
D
