Railway Equipment 934, Руководство по эксплуатации

Страница: 25 / 62

P/N R9340-0104 25 © 2010 RAILWAY EQUIPMENT CO.
REV B
5/11
3.
SET POINT:
The SET POINT menu has two selectable levels: BASIC or
ADVANCED. If the ADVANCED level is selected, the next screen
is PASSWORD. To adjust items on the ADVANCED menu, enter
PASSWORD: 5 by rotating RE1. The ADVANCED menu includes
the BASIC menu items as well as the ADVANCED items listed.
BASIC
A. SELECT TEMERATURE SETPOINT:
Used to set temperature below which unit will start. Factory
default is 38 degrees F (3.3 degrees C).
B . SELECT RUN TIMER VALUE:
The run timer can be set from 0 to 1000 minutes in 1 minute
increments. If zero is selected, the unit will operate until
the control on contact closure is removed. If any value other
then zero is selected, a control on circuit closure will cause the
unit to run for the amount of time set. When the count down
timer reaches zero, the unit will shut down and drop indication.
To restart the unit, the control on contact closure must be opened
and closed again. Factory default is zero.
C. SELECT SNOW TIMER
The snow timer can be set from 1 to 1000 minutes in 1 minute
increments. The EHAB unit will run as long as snow is detected.
The value selected is the amount of time the unit will after snow is
no longer detected. Factory default is 60 minutes.
D. SELECT SNOW SENSOR SPEED
Snow sensor speed can be set from 1 to 60 seconds. This sets
the amount of time the EHAB must continuously sense snow
before starting. Factory default is 1 second.
E. SELECT START DELAY
Starting the motor can be delayed using this parameter. This
allows a staggered start for multiple units on the same power
hook up. The parameter can be set from 0 to 240 seconds in
10 second increments.
ADVANCED
A. PROG REV/DATE