Set Up Checklist
- Lubricate the locomotive
- Check to see whether the battery needs to be charged for full sound effects
- Prime the smoke unit
- Apply power to run as described in the Basic Operating Section of this manual
Lubrication
You should lubricate the engine to prevent it from squeaking. Use
light household oil and follow the lubrication points marked “L”
shown below. Do not over-oil. Use only a drop or two on each pivot
point.
Priming the Smoke Unit
When preparing to run this engine, add 15-20 drops of smoke fluid through the
smokestack (see below). We recommend M.T.H. ProtoSmoke™ fluid. Do not
overfill the unit or the fluid may leak out and coat the interior engine components.
If you choose not to add smoke fluid (or have already added fluid but choose to
run smoke-free), turn off the smoke unit by turning the smoke volume control
fully counter-clockwise.
Failure either to add fluid to the smoke unit or to turn
it off may damage the smoke unit heating element and/or wicking material.
RailKing Coors Light The Silver Bullet
®
Steam Locomotive Set
3
DO NOT
OVER OIL
DO NOT
OVER OIL
DO NOT
OVER OIL
Running the engine without a primed
smoke unit may cause damage
Smoke Unit Switch Location
Smoke Unit Volume Control
Lubrication Points on the Locomotive
Lubricate Pick-Up Roller (L)
Lubricate Side Rods (L)
Lubricate Pick-Up Roller (L)
Lubricate Idler Gears & Axles (L)
Lubricate Idler Gear & Axle (L)
