Raider RD-MS21, Руководство пользователя, Страница: 20 / 94

20 www.raider.bg
screw (30).
• Raise the guard (6).
• Keep the spindle lock button (7) pressed
and loosen the bolt (19) using the spanner
(20).
• Remove the flange (21).
• Remove the saw blade (5).
• Mount the flange (21).
• Keep the spindle lock button (7) pressed
and tighten the bolt (19) using the spanner
(20).
• Lower the guard (6).
• Mount the bracket (29) by tightening the
screw (30).
ADJUSTING THE SAW ANGLE Fig. C
The mitre angle is left/right variable
between 0° and 45°. The mitre angle can be
read from the scale (9).
Do not set the mitre angle during use!
• Slacken the locking knob (8).
• Turn the saw table (13) to the required
position.
• Tighten the locking knob (8).
Setting up the double sawing angle /
mitring Fig. 2
Setting up the double sawing angle/
mitring Fig. D
• Adjust the first angle as described for
adjusting the saw angle (above).
• Turn the knob (10) anticlockwise and then
set the angle desired (you can read this off
on the back of the machine. Then tighten the
knob (10) again by turning it clockwise.
Changing the carbon brushes Fig. A
• Make sure that the plug is not in the
socket!
• Unscrew the covers (16) with a flat bladed
screwdriver. Remove the carbon brushes with
the same type of brushes. Screw the covers
(16) and tight again.
Note: Always replace both carbon brushes
at the same time. Never use a mixture of old
and new brushes.
Mounting the dust bag Fig. F
Press in the clamp of the dust bag (27) and
slide it onto the opening on the back of the
machine.
The dust bag stays in place when you
release the clamp.
8. OPERATION
Using the mitre saw Fig. A
Before use, always check for faults or
defects!
• Set the desired sawing angle of the
machine.
• Put the plug into the socket.
• Fix the piece of work in place using the
clamps (24): make sure that the material is
well clamped in place!
• Hold the material tightly on the left side
while making sure that you keep a safe
distance from the blade of the saw.
• Turn on the machine using the switch (1).
• Make sure that the saw blade has reached
full speed before allowing it to touch the piece
of work to be sawn.
• Use knob (2) to raise the protective cover
lock.
• Now bring the saw slowly downwards so
that the saw blade saws through the piece of
work and passes through the slot in the table.
Do not put any pressure on the saw. Give the
machine time to saw through the piece of
work.
• Bring the machine gently up again and
switch it off by letting go of the switch (1).
Using the laser
• To switch on the laser , press the on/off
switch .
• To switch off the laser , release the on/
off switch.
9. SERVICE AND MAINTENANCE
Always make sure that the machine is not
connected to the mains electricity when you
carry out any maintenance of the mechanism.
Slide rails
Dirt can damage the slide rails and
thereupon the operating of the machine.
• Clean the slide rails regularly with a soft
cloth.
• Drip some lubricating oil on the slide rails
• Move the mitre saw forwards and
backwards so the oil spreads over the
complete rails
These machines are designed to function
for a long time without any problems with a
minimum of maintenance. By cleaning the
machine regularly and using it in the correct
way you can contribute to a long life of your
machine.
Cleaning
Clean the machine housing regularly with
a soft cloth, preferably after each time you use