Raider Pro RDP-SGC08PRO, Руководство пользователя

Страница: 21 / 114

21
Problem Cause Remedy
No coating material is coming out of the
nozzle The nozzle is blocked
The ascending pipe is blocked
The small hole in the ascending pipe is blocked
Material adjustment knob turned too far to the (-)
The ascending pipe is loose
No pressure is built up in the container Clean
Clean
Clean
Turn to the (+)
Tighten pipe
Tighten container
The coating material drips from the nozzle The nozzle is loose
The nozzle is worn
Build up of coating material in the air cap and
nozzle
Tighten
Change
Clean
Spray too coarse Coating material has a too high viscosity
Too much material
Material adjustment knob turned too far to (+)
Nozzle dirty
Air filter very dirty
Not enough pressure built up in container
Dilute
Turn material adjustment knob to (-)
Clean
Change
Tighten container
The spray jet pulses Coating material in container is running out
The small hole in the ascending pipe is blocked
Air filter very dirty Refill
Clean
Change
Run in the coating material Too much coating material applied Turn the material
adjustment knob to the (-)
Too much coating material mist
(overspray) The distance to the object to be sprayed is too
large
Too much coating material applied Reduce spraying distance
Turn material adjustment
knob to the (-)
Environmental protection.
In order to protect the environment, the power tool, accessories and packaging must be suitably processed for the reuse of the raw
materials contained therein. Do not dispose of power tools in household waste! According to the EU Directive 2012/19 / EC on end-
of-life electrical and electronic devices and its validation as a national law, power tools that can no longer be used must be separately
collected and subjected to appropriate processing to recover the contents in them valuable secondary raw materials.
Troubleshooting