Raider Pro RDP-SGC08PRO, Руководство пользователя

Страница: 18 / 114

18 www.raider.bg
8. Adjust quantity of material
Set the volume of material by turning the knob on the paint gun trigger. And the scale of the
regulator serves as a guide:
Note: It is advisable to check the cardboard gun or similar surface to find the correct setting.
Important: Start spraying outside the target area and avoid splashes in the target area.
Press the ON / OFF switch and start painting.
+ rotating counterclockwise - Higher volume of material
- turning clockwise - lower material volume
3. DRAWING TECHNIQUE
● The spray result depends largely on the smoothness and purity of the sprayed surface. Therefore,
the surface must be carefully prepared and free from dust.
● Cover all surfaces that should not be sprayed.
● Cover screws or similar parts of the target object.
● It is recommended that the gun be tested on a cardboard or similar surface to find the right
settings. Important: Start spraying outside the target area and avoid interruptions within the target
area.
● Correctly (Figure 1a) Make sure you hold the gun at a distance of approx. 2.5-30 cm to the target
site.
● Incorrect (Figure 1b) • Dense fog, accumulation, uneven surface quality.
● The result of equal movement of the gun is equal and quality painting on the surface.
● In the coating material, build on the nozzle (A) and the air cap (B) (fig.2) clean both parts with
solvent or water.
B
A
а
b
Fig. 1 Fig. 2
Termination of work
● Turn off the machine.
● Put the pistol in its stand.
20-30cm