Raider NSN 3HD 2805-01-652-3076, Руководство пользователя

Страница: 74 / 78

64
g. Fuel Pumps
 Inspect component for leaks, damage, or excessive wear.
 Inspect Clamps: Ensuring proper fit, note leaks, damage, or
excessive wear.

Inspect Lines: Check for dry rot and chaffing.
g.
h. Carburetors

Inspect component for leaks, damage, or excessive wear.

Inspect Clamps: Ensuring proper fit, note leaks, damage, or
excessive wear.

Inspect Lines: Check for dry rot and chaffing.
h.
i. Primer

Inspect for damage due to corrosion, lack of maintenance, or
abuse. Loose ball joints, locknuts, bent link rods, loose rod snaps.
 Lubricate with Friction Surface Marine Grease.
i.
Operational Checks
Completed
(initial)
a. Pull Start

Start the motor using the recoil starter. a.
b. Electric Start 
Start the motor using the electric start push button.
b.
c. Neutral Safety

Verify that the motor will not start in gear both forward and
reverse.
c.
d.
Water discharge from
check ports  When the motor is running verify that water is being discharged
from all check ports.
d.
e. Tiller Steering

When moving the Tiller Arm, verify that the motor moves freely
to port and starboard.
e.
f. Neutral
 Verify the propeller does not engage when the gear selector is in
the neutral position.
f.
g. Forward

With the motor at idle, verify the Gear Selector moves freely into
the forward position and the propeller engages.
g.
h. Reverse

With the motor at idle, verify the Gear Selector moves freely into
the reverse position and the propeller engages.
h.
i. Throttle Control

With the engine in neutral, slowly increase the throttle RPM’s to
approximately.
i.
j. Emergency Stop Switch

While the motor is running, remove the lock plate, the motor
should stop.
j.
k. Engine Stop Switch

While the motor is running, press the Engine Stop Switch, the
motor should stop.
k.
l. Shallow Water Running

Move the motor Reverse Lock Lever to the release position, lift
the lower unit past a 45° angle until the tilt stopper assembly
locks.
l.
m. Full Tilt Position

Move the motor Reverse Lock Lever to the release position, lift
the Lower Unit past a 90° angle until the tilt stopper assembly
locks.