RAIDExpress 133 RAID USER MANUAL
58
insmod /lib/iteraid.o
<-- new insert line
...
...
================================================
# umount /mnt/initrd
# gzip -c /tmp/initrd.ext2 > /boot/initrd-2.4.18-3.img
If you are using Lilo to boot your system, you also need to run
lilo:
# lilo
Then reboot your system and the driver will be loaded.
3.1.5
Configure system to mount volumes during startup.
Now you can inform the system to automatically mount the
array by modifying the file /etc/fstab. E.g. You can add the
following line to tell the system to mount /dev/sda1 to location
/mnt/raid after startup:
/dev/sda1 /mnt/raid
ext2
defaults
0
0
3.2 Installing Red Hat Linux on IT8212 Controller.
3.2.1
Prepare your hardware for installation.
After attaching your hard disks to IT8212 controller, you can use
IT8212 BIOS to configure your hard disks as RAID 0, RAID 1,
RAID 0/1 or JBOD arrays, or just use them as single disks.
Remember to set the BOOT disk in the IT8212 BIOS
configuration menu.
Before installation, you must remove all the disk drives, which
