6
Operating the EntryRAE
3.1 The time is shown in 24-hour format, and the
date is shown in “ddmmyy” format.
3.2 If the monitor has never been programmed, you
will see a “date error” message. Press @ to
acknowledge the error. (Refer to “Adjust Date?”
on page 20 to reset the time and date.)
3.0 The Time and Date settings are checked:
Operating the EntryRAE
The external filter must always be used with the monitor.
Turning the Monitor On
!
2.1 The EntryRAE firmware version displays.
2.2 All of the display segments appear.
2.3 The buzzer sounds twice (if the unit has not
been set to run silently; see page 24), the LEDs
blink twice, and the vibration alarm turns on and
off.
2.4 The preset alarm limits appear in order:
HIGH, LOW, TWA, STEL.
To turn the monitor on
:
1.0
Press the @ (mode) key for 1 second.
2.0 The warm-up sequence begins:
4.0 PID Warm-up:
4.1 If the monitor has not been used recently, PID
warm-up of up to three minutes (180 seconds)
occurs. During this time, the PID lamp icon
appears, as well as a countdown from 180 to 1.
