RADWAG X2 Series, Руководство пользователя

Страница: 7 / 30

- 7 -
AS X2.PLUS balances
1. power supply seat
2. DB9/M connector (external buttons)
3. COM 1 connector (e.g. printer)
4. USB 2 type B connector (e.g.
computer)
5.
USB 1 type A connector (e.g.
computer keyboard)
6.
RJ45 Ethernet connector
1.3. INTENDED USE
X2 series balances are designed to provide accurate measurement of weighed loads, performed
under laboratory conditions.
1.4. PRECAUTIONS
•
Prior to first use, it is highly recommended to carefully read this User Manual, and operate the
balance as intended.
•
Do not operate the touch panel using sharp-edged tools (knife, screwdriver, etc.).
•
While loading the balance make sure that loads are placed in the very centre of the weighing
pan.
•
Load the weighing pan with loads, gross weight of which does not exceed instrument’s
measuring range (maximum capacity).
•
Do not leave heavy loads on the weighing pan for a longer period of time.
•
In case of failure, immediately unplug the instrument from the mains.
•
Balances to be decommissioned, should be decommissioned in accordance with valid legal
regulations.
•
Do not use the balance is areas endangered with explosion. The X2 series is not designed to
operate in EX zones.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
NOTE:
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: