RADLEY 1281-914, Руководство пользователя

Страница: 9 / 20

8
1281-914
Never touch the bit during or immediately after use.
After use the bit is too
hot to be touched by bare hands.
When using any new accessory for the first time, particularly wire wheels,
bristle brushes and grinding stones, run the tool at full speed for one minute
to remove any loose wires, bristles or stone particles. During this initial run-up,
always wear a face shield and make sure you are NOT in line with the rotating
accessory to avoid injury caused by flying debris.
GUIDELINES FOR EXENSION CORDS
Make sure your extension cord is the proper size. When using an extension cord,
be sure to use one heavy enough to carry the current the tool will draw. An
undersized cord will cause a drop in line voltage resulting in loss of power and
overheating. The table on at right shows the correct size to use according to cord
length and nameplate ampere rating. If in doubt, use the next heavier gauge. The
smaller the gauge number the heavier the cord.
Be sure your extension cord is properly wired and in good condition. Always
replace a damaged extension cord or have it repaired by a qualified electrician
before using it. Protect your extension cord from sharp objects, excessive heat and
damp or wet areas.
Use a separate electrical circuit for your power tools. This circuit must not be less
than 14-gauge wire and should be protected with either a 15A time delay fuse or
circuit breaker. Before connecting the power tool to the power source, make sure
the switch is in the OFF position and the power source is the same as indicated on
the nameplate. Running at lower voltage will damage the motor.
WARNING: Repair or replace damaged or worn extension cords immediately.
Select the appropriate extension cord gauge and length using the chart to the below.
When operating a power tool outdoors, use an outdoor extension cord marked “W-A”
or “W”. These cords are rated for outdoor use and reduce the risk of electric shock.
WARNING: Keep the extension cord clear of the working area. Position the
cord so it will not get caught on the workpiece, tools or any other obstructions
while you are working with the power tool.