8
1270-080
Never use dull or damaged blades. Sharp blades must be handled with care.
Damaged blades can snap during use. Dull blades require more force to cut the
workpiece, possibly causing the blade to break.
Never touch the blade during or immediately after use. After use the blade is too
hot to be touched.
GUIDELINES FOR EXTENSION CORDS
WARNING: Keep the extension cord clear of the working area.
Position the cord
so it will not get caught on the workpiece, tools or any other obstructions while you
are working with the power tool.
Make sure any extension cord used with this tool is in good condition. When using
an extension cord, be sure to use one of heavy enough gauge to carry the current
the tool will draw. An undersized cord will cause a drop in line voltage resulting in
loss of power and overheating.
The table below shows the correct size to use according to cord length and
nameplate ampere rating. If in doubt, use the next heavier gauge. The smaller the
gauge number the heavier the cord.
Be sure your extension cord is properly wired and in good condition. Always
replace a damaged extension cord or have it repaired by a qualified electrician
before using it. Protect your extension cord from sharp objects, excessive heat and
damp or wet areas.
Use a separate electrical circuit for your power tools. This circuit must not be less
than 14 gauge wire and should be protected with either a 15 AMP time delayed
fuse or circuit breaker. Before connecting the power tool to the power source,
make sure the switch is in the OFF position and the power source is the same as
indicated on the nameplate. Running at lower voltage will damage the motor.
WARNING: Repair or replace damaged or worn extension cords immediately.
Select the appropriate extension cord gauge and length using the chart below.
When operating a power tool outdoors, use an outdoor extension cord marked "W-A"
or "W". These cords are rated for
outdoor use and reduce the risk of
electric shock.
WARNING: Keep the extension
cord clear of the working area.
Position the cord so it will not get
caught on the workpiece, tools or
any other obstructions while you
are working with the power tool.
MINIMUM GAUGE (AWG) EXTENSION
CORDS
(120 V use only)
Ampere rating
Total length in feet
More
than
Not
more
than
7.5 m
(25')
15 m
(50')
30 m
(100')
45 m
(150')
0
6
18
16
16
14
6
10
18
16
14
12
10
12
16
16
14
12
12
16
14
12
Not Applicable
Содержание 1270-080
Страница 1: ...1270 080 3042597 JD3507U Owner s Manual...
