11
6 Amp Reciprocating Saw - Owner's Manual
INSTALLING A BLADE
WARNING: Always remove the plug from
the power source before installing or
removing a blade or adjusting the saw in
any way.
1.
To install a blade in the saw, rotate
the blade locking sleeve (1) counter
clockwise (Fig. 1).
2. Insert the appropriate blade (2) into the
blade slot (3) as far as it will go.
3. Release the blade locking sleeve.
NOTE:
The blade will automatically be locked
into the blade holder. Pull outward on the
blade to ensure it is properly locked into the
blade holder.
REMOVING A BLADE
To remove a blade, simply rotate the blade
locking sleeve counter clockwise and remove
the blade from the blade holder.
ADJUSTING THE PIVOTING SHOE
The pivoting shoe will pivot to follow the
angle of the blade to the workpiece. This
action ensures the flat surface of the shoe
is against the workpiece for better cutting
action and easier control of the saw.
The shoe can be adjusted in or out,
allowing the use of the blade teeth at
different points on the blade. This will
provide longer blade life as one section
of the blade becomes dull.
1.
To adjust the pivoting shoe (1), loosen
the pivoting shoe hex screws (2) on
the lower side of the saw using the
4 mm hex key (3) (Fig. 2).
2. Slide the pivoting shoe in or out until
it is in the appropriate position.
3. Lock the pivoting shoe in place by
tightening the pivoting shoe hex screws.
4. Pull outward on the pivoting shoe to
ensure it is firmly locked in place.
VARIABLE SPEED TRIGGER SWITCH
The variable speed trigger switch controls
both the ON/OFF function and the speed
of the tool.
1.
To turn the saw ON, squeeze the
switch trigger (1) slightly (Fig. 3).
NOTE:
The saw will start at its slowest
speed.
ASSEMBLY AND OPERATING
NOTE:
The drawings in the assembly and
operating section of this manual may differ
slightly from the tool you purchased.
Fig. 1
1
2
3
Fig. 2
1
2
3
Содержание 1270-080
Страница 1: ...1270 080 3042597 JD3507U Owner s Manual...
