15
LED WORK LIGHT
The LED work light (3) will automatically turn ON when the trigger switch is squeezed
(Fig. 7). It will automatically turn OFF when the trigger switch is released.
3
Fig. 7
WARNING: For safety reasons, the operator must read the sections of this
Owner’s Manual entitled "GENERAL SAFETY WARNINGS", "POWER TOOL SAFETY",
"SPECIFIC SAFETY RULES", "BATTERY & CHARGER SAFETY" and "SYMBOLS"
before using this impact driver.
Verify the following every time the cordless driver is used:
1. Safety glasses, safety goggles, or face shield is being worn.
2. Hearing protection is being worn.
3. The screwdriver bit is single ended and has the ANSI groove on one end.
4. The screwdriver bit is correctly installed and locked into the collet.
5. The bit is in good condition, and is fully inserted into the bit holder.
Failure to observe these safety rules will significantly increase the risk of injury.
PREPARING SCREW HOLES
It is important to prepare screw holes before attempting to fasten two pieces of wood
together. Proper preparation will make screws drive easier and prevent misaligned
components, stripped screw heads, splitting and separating of wood components.
Fig. 9
Fig. 8
1. Clamp the components that are to be screwed together in their desired position (Fig. 8).
