14
1239-222
ASSEMBLY AND OPERATING
(continued)
FORWARD / REVERSE SWITCH
The forward/reverse switch (1) is conveniently mounted above the trigger switch (2)
(Fig. 6). To make the drill rotate clockwise (for drilling) push the forward/reverse switch
to the left. To make the drill rotate counterclockwise for removing screws, push the
forward/reverse switch to the right.
NOTES:
a) Never change the position of the forward/reverse switch while the chuck is turning.
b) The trigger switch will NOT function with the forward/reverse switch in the middle position.
This drill is equipped with a variable-speed ON/OFF trigger switch.
1.
To start drill, gently squeeze the trigger switch (2) (Fig. 7).
NOTE:
The drill will turn at its slowest speed when the trigger switch is depressed
slightly. The drill will turn at its fastest speed when the trigger switch is fully depressed.
2.
To stop the drill, release the trigger switch.
NOTE:
Drilling at a slow speed for an extended period of time may cause the drill motor
or the battery pack to overheat. If either the drill or the battery gets hot, stop drilling and
allow them to cool for at least 15 minutes.
LED WORKLIGHT
The LED worklight (3) will automatically turn ON when the trigger switch is squeezed
(Fig. 8). It will automatically turn OFF when the trigger switch is released.
The two-speed gear box switch is located on the top of the drill housing. Set the
speed-control switch to the desired speed before starting the drill. Slide the speed-control
switch FORWARD (Fig. 9a) for low-speed operation. Slide the speed-control switch
BACK (Fig. 9b) for high-speed operation.
NOTES:
Use low-speed setting for drilling large holes and for driving screws.
Use high-speed setting for drilling smaller holes.
Do NOT change the speed-control switch position while drill is turned ON.
Damage to the gears may result.
