Radionics Security System, Руководство пользователя

Страница: 10 / 36

10
How Your System Reports Alarms
Your security system may be programmed to automatically
disconnect your telephones when sending reports to your security
company. Once the report is completed, your security system returns
the telephones to normal operation (check with your security
company).
Your system makes repeated attempts to send reports to your
security company. In the event your system fails to report, the keypad
will signal a system trouble. Follow the
Checking System Troubles
procedure.
Note: If your telephone service is interrupted, your security system
cannot send reports to your security company unless it has an
alternate means of transmitting them.
Silencing Alarms
When there is an alarm, the alarm tone sounds and the point or
points in alarm light up. If you enter your passcode before the system
dials your alarm company, the alarm is canceled.
1. When an alarm occurs, the OK light and point lights (1 to 8)
flash. For example if point 4 produces the alarm event, then point 4
flashes:
2. Enter your passcode to silence the alarm. If you enter your
passcode before the system dials your alarm company, the alarm is
canceled and the OK light stops flashing. If the OK light continues to
flash, an alarm report was sent to your alarm company.
3. Use Viewing Alarm Memory to review the points that caused the
alarm. Use Resetting The System to reset the OK light and clear alarm
memory.
71-07374-000-B Users Guide.p65 08/21/2001, 1:05 PM 10