D6680
Network Adapter
Installation Guide
1.0
Introduction
The Radionics D6680 Network Adapter is a two-channel network adapter. The D6680 includes a cable for
connecting to DB25 Channel 1 Port. For most NetCom installations, only one channel needs to be used and
configured.
These instructions should be followed to avoid the possibility of physical damage to the operator,
program and/or equipment.
1.1
Network Interface
Figure 1: Network Interface
Note:
Do not attempt to connect both Ethernet ports
simultaneously. The D6680 does not have
routing capabilities.
The D6680 has the following items on the
Network Interface end of the unit.
1. 10BASE-T Ethernet Port (refer to Figure 2)
2. 10BASE-FL Ethernet Port (Transmit)
– Not Used
3. 10BASE-FL Ethernet Port (Receive)
– Not Used
4. Network
LEDs
5. Power
Plug
1.1.1
RJ-45 10BASE-T Ethernet Port
Figure 2: RJ-45 Ethernet Jack Pinouts
1.2
Serial Interface
Figure 3: Serial Interface
The D6680 has the following items on the
Serial Interface end of the unit.
1. DB9 Serial Port (DTE) – Not Used
2. Serial
LEDs
3. DB25 Serial Port (DCE)
1.2.1
DB25 Serial Port (DCE)
Figure 4: 25-pin Serial Port
