Radionics D6600 NetCom, Системное руководство

Страница: 19 / 100

D6600 NetCom
Communication System Overview
D6600 NetCom System Guide
© 2001 Radionics Page 19 46542C
The IP Configuration window should appear:
Note: Make sure that the Network Adapter is selected in
the first window, not a PPP adapter. Verify the IP
address, subnet mask, and whatever other
information is listed. (This information should
match the IP and subnet mask you assigned to
this computer in the previous steps).
IF YOU HAVE CHOSEN TO PROGRAM THE D6600’s INITIAL NetCom PARAMETERS VIA THE
DIRECT NULL MODEM SERIAL CONNECTION, THEN CONTINUE ON WITH THE FOLLOWING STEPS.
These steps are ONLY necessary if the host computer running the D6200 Software is connected to
the D6600’s COM4 port via a direct NULL modem serial cable!
9. In Microsoft
®
Windows
®
operating system, click on
the Start button and then go to Settings and Control
Panel.
10
. Once the control panel is open, find and
double-click on the “System” icon to
launch the System control panel.
9. From the Device Manager tab, select Ports. Highlight
the COM port (usually COM1) used to connect the
D6200 Software to the D6600 COM4 port via a direct
connect NULL Cable.
10. Highlight the port icon and
then click on the "Properties…"
button.
11. Under the
Port Settings
tab, select
38400 bits
per second
baud rate
and then
click OK.