RadioLink Electronic Limited
7
1.2.2 Receiver Installation and Binding
Binding
1. Put the transmitter and the receiver close to each other (about 50 centimeters) and power both on.
2. Switch on the transmitter and the LED on R6FG will start flashing slowly.
3. There is a black binding button(ID SET) on the side of receiver. Press the button for more than 1 second
and release, the LED will flash quickly, meaning binding process is ongoing.
4. When the LED stops flashing and is always on, binding is complete and there will be a signal tower shown
on top of the LCD screen of the transmitter. If not succeed, the LED will keep flashing slowly to notify, repeat
the above steps.
Note
1. The binding between your R6FG and RC4GS V3 is already complete by default. Just need to make sure
there is the solid light of R6FG and the signal tower in the transmitter.
2. NO gyro by default as factory setting. Since integrated gyro in R6FG will self-check, it is very important
to remain R6FG still when powering it on. There are two LED indicators on R6FG. GREEN indicates the
normal working mode while RED indicates the gyro working mode. When RED is off means NO gyro. If
binding is not successful, the green LED will keep flashing to notify.
Note of Receiver Usage
1. Keep antennas as straight as possible, or the effective control range will reduce.
2. Big models may contain metal parts that influence signal emission. In this case, antennas should be
positioned at both sides of the model to ensure the best signal status in all circumstances.
3. Antennas should be kept away from metal conductor and carbon fiber at least half inch away and no over
bending.
4. Keep antennas away from motor, ESC or other possible interference sources.
5. Sponge or foam material is advised to use to prevent vibration when installing receiver.
6. Receiver contains some electronic components of high-precision. Be careful to avoid strong vibration and
high temperature.
7. Special vibration-proof material for R/C like foam or rubber cloth is used to pack to protect receiver.
Keeping the receiver in a well sealed plastic bag can avoid humidity and dust, which would possibly make the
receiver out of control.
When all the above steps are complete, please turn off the transmitter and re-power on to test if the receiver is
correctly connected with it.
1.2.3 Working Mode
R6FG has two working modes
：
normal working mode and gyro working mode. Short press the binding button
(ID SET) three times with interval less than 1 second to switch the working modes.
1. Normal Working Mode
Green LED, gyro will NOT be working.
2. Gyro Function Working Mode
Both GREEN and RED LED on.
Note 1. Gyro is off by default. Since there is self-check for gyro, please keep the receiver stationary when
powering on.
Note 2. When the receiver is connected to the power supply, if there is no successful binding between the
receiver and the transmitter or the receiver loses the signal, the indicator of the receiver will flash slowly.
