RadioLink Electronic Limited
31
Transmitter voltage is low
Receiver voltage is low
RC model battery voltage is low
The RSSI alarm value is turned off
by default. Users can set it as the RSSI value corresponding to the farthest
safe distance of the actual control. For example, the farthest remote control
distance is 400m, the corresponding RSSI value is -85dBm, then you can set
the RSSI alarm value as -85dBm. When the vehicle is running, if the
transmitter battery or vehicle battery is exhausted, or the RSSI signal is week,
the vehicle will lose control. Therefore, when the alarm sounds, please stop
driving immediately and take the vehicle back, check the cause of the alarm,
and deal with it properly. The alarm prompt is as right:
2.20 Gyro Sensitivity “GYRO”
This function is available to set gyro sensitivity and VR mixing ON or OFF.
When MIX set OFF, gyro is disabled while when MIX set ON, you can adjust
gyro sensitivity STD or VR. STD is adjusted on screen and VR is default CH3.
In normal mode (STD), range of sensitivity is 0%-100%.
(1) Enter the menu, use Dec(-) and Inc(+) to select options for gyro sensitivity.
(2) Press the key button “Enter” to enter sub-menu gyro sensitivity.
(3) Press “Enter” again, the initial value will start flashing, then use Dec (-) and
Inc (+) to change the value.
(4) Press the button key “Enter”, the value stops flashing, the setting is
finished now.
(5) "Mode"and "Rate" can also be set by the same step.
(6) Press button key “Exit” to be back to initial screen.
2.21 Fail Safe”F/S”
This function is set by servo, throttle, CH3, CH4, and CH5.
Option:
ST: Steering(CH1)
TH: Throttle(CH2)
CH3: Channel3(VR)
CH4: Channel4(SWA)
