RadioLink Electronic Limited
23
Dual Rate Setting
:
(1) Long press "Exit" and "Enter" button simultaneously for one second to enter the function menu of RC4GS
V3. Press "Inc(+)" button at the bottom of the screen to move the cursor to "13. D/R", and then press " Enter”
button to enter the function setting interface.
(2) Switch setting: Set a switch or button to switch in different travel amount of each channel.
A. You can set SWA, SWD, or the lock modes of these two switch buttons LK-A, LK-D.
B. "NULL" means no switch assigned. After setting the travel amount of the corresponding channel, the
transmitter will always execute the set value by default.
C. UP (up)/DOWN (down): It indicates the position of the selected switch. Push/Press the switch to
different positions to set different travel amount.
D. Setting method: Press "Dec(-)" or "Inc(+)" button at the bottom of the screen to move the cursor to
"NULL" next to the switch, then press "Enter" button, the corresponding setting starts to flash, then press
"Dec(-)" or "Inc(+)" button to select the switch or button to be set, and press "Enter" button to confirm the
option after the selection. The switch setting stops flashing and the switch setting is complete.
(3) Set the travel amount of each channel: press “Dec(-)” or “Inc(+)” button to move the cursor to the rate next
to the channel, and then press the “Enter” button, the corresponding value starts to flash , and then press
“Dec(-)” or “Inc(+)” button to adjust the rate value. After setting, press "Enter" button, the rate value stops
flashing, and the channel rate value is set.
(4) Press "Exit" to return to the home page.
Example
:
1. If you set SWA or SWD switch. Press it to one dual rate value, and release it to another dual rate value.
2. LK-A, LK-D are corresponding to the lock mode of SWA, SWD switches. Press it to one dual rate value,
and press it again to another dual rate value.
2.15 Brake Side Adjustment "ATL"
Brake side adjustment
This function decreases the set value when the braking effect is strong and
increases the set value when the braking effect is weak.
Setup Item
RATE: Brake amount
Brake amount (RATE)
0%~100%
Initial value: 100%
(1) Enter the function menu and use “Dec(-)” or “Inc(+)”button to access ATL
function.
(2) Press “Enter” button to get into ATL function interface.
(3) Press “Enter” key, and the initial value of RATE will blink. Use “Dec(-)”or“Inc(+)” button to adjust the value.
(Note: In the interface of adjusting the value, return to the initial value "100%" by pressing “Dec(-)” and “Inc(+)”
buttons simultaneously for about 1 second.)
Press “Enter” button, the adjusted value stops blinking, now the value has been set.
(4) When ending setting, return to the initial screen by pressing“Exit” button twice.
