Code-matching method between transmitter and receiver:
1
．
Load the battery into transmitter, power on it.
2
．
Connect the power to the 2nd Channel pin of receiver.
3
．
Press the binding button on the receiver till LED starts twinkling.
4
．
LED stops the twinkle, bright light indicates a successful
code-matching was completed.
Display whenpower
on
R4EH-G is intergrated with gyro,it can make cars run stablely, the effect is more obvious
when the car is turning. The gyro function can be set "ON"and "OFF"
Description of indicator light:
1.Receiver in normal working condition: Green light on
2.Gyro in working normal condition:Red light on
Attention:The gyro function was set to on by factory.When the receiver is in working condition
At this time,
the red light flashing,the gyro enter a self-examination state.
please keep the
receiver in a stable condition.
In normal condition, the direction of cars including forward and backward.
Method of using receiver intergrated with gyro
The gyro should
only work in forward direction.
only when choosing the correct direction,can the gyro really work.
Attention:The vehicle gyro has the phase adjusting function,
Gyro function settings:
1.Usage method of gyro:Short press the code key for three times(time interval between
each time lasts less than 1 second ), the red light continuous flashing three times, then
the red light into a lasting bright , it shows the gyro in a normal state.
2.The gyro sensitivity: The default is three channel. The VR switch can be used for real-
time adjustment when the radio control works,to ensure that the third channel VR control
(Factory default)
clockwise, the sensitivity increases, counterclocwise, the sensitivity decreases.
Attention:Sensitivity shuoldn't be set to 0.
7
