18
3.If initial MODE setup item is SPEED 2,{ if initial MODE setup item is SPEED 1,
you need to select SPEED 2 by pressing “Dec(-)” or “Inc(+)” button to select MODE
setup item , then press “Enter” key, SPEED 1 or OFF will blink, press “Dec(-)” or
“Inc(+)” button,when the blinking SPEED 1 or OFF change to blinking SPEED
2,press “Enter” key,SPEED 2 will stop blinking, now SPEED 2 is selected}, press
“Dec(-)” or “Inc(+)” button to select "LOW" or "HIGH" delay adjustment or
“TGP1” Speed switching point adjustment.
4.Press “Enter” key to confirm "LOW" or "HIGH" or “TGP1” setup item, and the
value of your selected setup item will blink. Use “Dec(-)” or “Inc(+)” button to adjust
the value.
(Note: In the interface of adjusting the value, return to the initial value
（
the initial
value of LOW and HIGH is “100”, the initial value of TGP1 is “30”
）
by pressing
“Dec(-)” and “Inc(+)” buttons simultaneously for about 1 second.)
Press “Enter” button, the adjusted value stops blinking, now your selected value has
been set.
5.When ending setting, return to the initial screen by pressing “Exit” button twice.
Pulse brake
When the brakes are applied while cornering with a 4 Wheel Drive or other type of
vehicle, understeer may occur. The generation of understeer can be eliminated and
corners can be smoothly cleared by using this function.
Operation
- When the brakes are applied, the throttle servo will pulse intermittently. This will
have the same effect as pumping the brakes in a full size car.
- The brake return amount, pulse cycle, and brake duty can be adjusted.
- The region over which the ABS is effective can be set ac-cording to the steering
operation. (Mixing function)
Setup items
ABP: Brake return amount
A.B.S. Function "A.B.S"
