RadioLink Byme-DB, Инструкция по эксплуатации

Страница: 5 / 13

4
Specifications
Dimension：29*25.1*9.1mm
Weight (With wires): 4.5g
Channel Quantity: 7 channels
Integrated Sensor: Three-axis gyroscope and three-axis acceleration sensor
Signal Supported: SBUS/PPM
Input Voltage: 5-6V
Operating Current: 25±2mA
Flight Modes: Stabilize Mode, Gyro Mode and Manual Mode
Flight Modes Switch Channel: Channel 5 (CH5)
Motor Lock Channel: Channel 7 (CH7)
Socket Specifications: CH1, CH2 and CH4 are with 3P SH1.00 sockets; The receiver connect socket is 3P PH1.25 socket; CH3 is
with a 3P 2.54mm Dupont Head
Transmitters Compatible: All the transmitters with SBUS/PPM signal output
Models Compatible: All model airplanes with mixed elevator and aileron controls including delta wing, paper plane, J10,
traditional SU27, the SU27 with rudder servo, and F22, etc.
Installation
Make sure the arrow on Byme-DB points to the aircraft head. Use 3M glue to flatly attach Byme-DB to the fuselage. It is
recommended to install it near the center of gravity of the aircraft. Byme-DB comes with a receiver connect cable which is used
to connect the receiver to Byme-DB. When connecting the servo cable and ESC cable to Byme-DB, please check whether the
servo cable and ESC cable match the sockets/head of Byme-DB. If they do not match, the user needs to modify the servo cable
and ESC cable, and then connect the cables to Byme-DB.