Radiocrafts
Embedded Wireless Solutions
RC2300DK/RC2301DK
©
2007 Radiocrafts AS
RC2300DK/RC2301DK Demonstration Kit User Manual (rev. 2.0)
Page 8 of 17
Debug and programming interface
The Demonstration Board provides a DEBUG interface used to program firmware into the on-
board module and for debugging the code. The DEBUG interface is compatible with the
DEBUG interface at the Texas Instruments / Chipcon SmartRF04EB board. This board and its
associated software are available from TI / Chipcon. The table below shows the P8 SOC
debug connector pin-out. See figure Figure 4.
Another option for programming is a third party programmer as FlashPro-CC from Elprotronic,
as shown in Figure 5
Below is shown how to connect the RC2300DB to the SmartRF04EB.
Debug interface pin
Function
1 GND
2
VCC (Insert jumper at P10 to connect
VCC from target to the
programmer/EB)
3 Debug
Clock
(DC)
4
Debug Data (DD)
5 CSn
(optional)
6 SCL
(optional)
7 RESET_N
8 MOSI
(optional)
9 NC
(not
connected)
10 MISO
(optional)
