RT-CRC1 User’s Guide
Copyright © 2010, Radio-Tone. All Right Reserved.
6
PTT Mode for [ A RX/TX ] Terminal
Turn ON the power of the radio units.
Turn ON the power of the RT-CRC1. The [ Status ] Indicator of the RT-CRC1 will BLINK
with ORANGE COLOR for approximate 20 seconds.
Push and hold the PTT switch of any radio unit with DTMF function.
Key-in the PTT mode selection code “1234” and then followed by the mode number “ 4 ”
or “ 5 ” to setup the PTT Mode of [ A RX/TX ] Terminal. That means “ 12344 ” for PTT
Mode 1, and “ 12345 ” for PTT Mode 2. The [ Status ] Indicator of RT-CRC1 is changed to
BLINK with RED COLOR. The blinking codes are:
ONE SHORT ON : PTT MODE 1
TWO SHORT ON : PTT MODE 2
After release the PTT switch, the new PTT Mode of [ B RX/TX ] Terminal will be stored in
the memory of the RT-CRC1.
Simple Repeater Operation
Turn ON the power of the radio receiver unit, radio transmitter unit and RT-CRC1. The
system will standby for radio repeater function. The [ Status ] Indicator will BLINK with
ORANGE COLOR for approximate 20 seconds, and then BLINK with GREEN COLOR.
Push and hold the PTT switch of any other radio unit to perform a radio call.
The receiver unit will receive the radio call and then trigger the RT-CRC1.
The [ Status ] Indicator of the RT-CRC1 will LIGHT UP with RED COLOR, and control the
transmitter unit.
Then the transmitter unit will repeat the radio call to another channel.
Remote Control Repeat Function OFF (Radio Link at [ A RX/TX ] Terminal Only)
Push and hold the PTT switch of any other radio unit with DTMF function to perform a radio
call.
The receiver unit will receive the radio call and then trigger the RT-CRC1.
The [ Status ] Indicator of the RT-CRC1 will LIGHT UP with RED COLOR, which indicates
the repeat function is turned to ON.
Key-in a 4-digit password followed by “
*
” key, for example, “ 8888
*
”.
The [ Status ] Indicator of the RT-CRC1 will LIGHT UP with ORANGE COLOR, and the
Repeat Function is turned to OFF now.
Remote Control Repeat Function ON (Radio Link at [ A RX/TX ] Terminal only)
Push and hold the PTT switch of any other radio unit with DTMF function to perform a radio
call.
The receiver unit will receive the radio call and then trigger the RT-CRC1.
The [ Status ] Indicator of the RT-CRC1 will LIGHT UP with ORANGE COLOR, which
indicates the repeat function is turned to OFF.
