9
Installation
4. Remove the plastic trim ring by lifting the
top of the trim ring.
5. Insert the supplied keys into the slots at
both sides of the CD player, and slide
the CD player out of the dash.
6. Remove the keys from the slots.
7. Disconnect the 14-wire harness and the
antenna.
8. If you are mailing or shipping the CD
player, reinstall the shipping screws in
the top of the CD player.
9. Reconnect the cable to the vehicle’s
negative (–) battery terminal.
Mounting in Toyota, Nissan and Suzuki Vehicles
If your vehicle is a Nissan, Toyota, or Suzuki, follow these mounting instructions or contact
your nearest Toyota, Nissan or Suzuki dealer for installation information.
Use the screw holes marked T (Toyota), N (Nissan) or S (Suzuki), located on both sides of the
CD player to fasten the CD player to the factory radio mounting brackets supplied with your ve-
hicle.
1. Use a Phillips screwdriver to loosen and
remove the hook’s screws on the front
left and right side of the CD player.
2. Align the screw holes on the bracket
with the screw holes on the CD player,
then tighten the screws on each side.
3. Fasten with the supplied truss screws (5
×
5
mm) or flush surface screws (4
×
5
mm), depending on the shape of the
screw holes in the bracket.
Note: The mounting box, outer trim ring, and
sleeve are not needed for this type of instal-
lation.
Screw Selection Guide
Side view showing Screw
Holes marked T, N, or S
Vehicle Mounting
Brackets and Screws
Hook and Screws
Vehicle Mounting
Brackets and Screws
Screw Type
Quantity
Car Type
M 5
×
5 mm
4
T (Toyota),
N (Nissan)
M 4
×
5 mm
4
S (Suzuki)
12-2158.fm Page 9 Wednesday, September 13, 2000 1:50 PM
