Need help? Call 1-888-533-7135
11
IF YOU HAVE PROBLEMS
MANUAL CODE SEARCH
If the 3-in-One Easy Remote Control does not op-
erate your remote-controlled devices when you
first set it up, you might have to manually find the
correct code for your devices. You can try all the
codes listed in “Manufacturers’ Codes” on
Page 13 for the brand of your device, or you can
follow these steps to search the remote control’s
entire library.
1. Manually turn on the device you want to set
up.
2. Press the corresponding device key (
TV
,
VCR
, or
CBL
).
3. Hold down
P
until the red light blinks twice,
then press
9, 9
, and
1
. The red light blinks
twice again.
4. Aim the remote control at the device you
want to operate.
5. Repeatedly press
PWR
then the device key
for the device until it responds to the com-
mand.
6. When the device responds to the command,
press
P
within 5 seconds to save the code.
Note: If you do not press
P
within 5 seconds,
the remote control does not save the code.
• Because the remote control’s library has
so many codes, this procedure can take
several minutes.
• If your device turns off during the search,
but does not operate after you lock in the
code, begin the search again, pausing
longer between key presses.
If necessary, repeat these steps for each device.
15-1931.fm Page 11 Monday, July 19, 1999 2:26 PM