RADICAL AUDIO RA163.3, Руководство пользователя

Страница: 8 / 24

TWEETER INSTALLATION
The tweeter units come with two different mounting adaptors, suitable for flat surface of
flush mounting. After you have checked which tweeter location in your vehicle offers best
staging and smooth midrange reproduction, you can finally install the tweeters:
FLAT SURFACE MOUNTING
a
Using the flat bayonet lock base as a template, mark the two screw holes and drill
them by using a 3 mm drill bit. Secondly, mark and drill the 6 mm hole for the tweeter
lead wire to get through the panel.
s
Mount the flat tweeter adapter base to the panel using the two self-tapping screws
provided with the mounting hardware set.
d
Run the speaker wire included in the speaker wire kit from the crossover to the flat
adapter base. Connect the tweeter main wire to the wire extension coming from the
crossover.
f
Mount the main tweeter unit to the flat base by inserting the tweeter into the conical
mounting ring. Place this unit over the adaptor base, turning the tweeter clockwise.
This locks the tweeter unit in place.
FLUSH MOUNTING
a
Remove the panel you are going to install the tweeter, to check for proper clearance
behind it. The flush mount kit is 16 mm deep, so make sure there are no obstructions
behind the spot you choose.
s
Mark the centre of the spot and cut a hole with a diameter of 40 mm, for example
using a hole-saw attachment for your power drill.
d
Mount the spring bar to the flat bayonet lock base with the M4 metrical screw
included in the hardware set.
f
Assemble the tweeter by inserting the main unit from the backside to the flush mount
cup. Insert this unit into the hole you have cut, then lock the spring/flat base with the
tweeter unit by turning the flush mount cup clockwise.
g
Connect the speaker wire extension to the main leads.
h
Remount the doorpanel, window triangle etc.
j
You can now pinpoint the tweeter to the desired direction.
8
Fig.: Flat Surface Mounting
RA163.3 Manual 16.07.2002 18:38 Uhr Seite 8