21
RETURN FITTING ASSSEMBLY
The return fitting kit includes 3 parts: inlet fitting, inlet plate and back nut.
Install the inlet fitting into the pre-cut hole, slide the inlet plate over
the exposed threads and then thread the back nut onto the fitting.
DO NOT OVERTIGHTEN.
Back Nut
Inlet Fitting
Inlet Plate
Pool
Interior
Pool
Exterior
For additional return fittings, drill 3” ( with 3” hole saw) hole
12” down from top of panel. Edges will be sharp but not in contact
with liner or hands once wall fitting has been installed. Install return
wall fitting per directions, firmly.
Do not over tighten.
Note: For the Radiant LED light, drill hole 14” down from top
of panel. Installation is identical to return fitting.
The return faceplates are attached after the liner is installed.
The plastic coping is installed by simply placing coping lengths over
the pool wall and securing with screws on the exterior of the pool.
Place all coping lengths around pool, leaving a 1” gap between each
length. The coping gap may be offset from a compression seam.
Once all of the coping has been placed, secure the coping to the
pool wall with sheet metal screws provided.
THIS STEP CANNOT
BE SKIPPED.
Included are 5 sheet metal screws for each full size coping length.
For Premium 4” coping, 2 additional screws per coping length are
included to be placed on the inside of the coping and covered by
duct tape. The screws, placed at the appropriate intervals, are
essential to the secure installation and long term durability of the
coping. The screw spacing should be as follows:
• One screw approximately 2-3” from each end.
• One screw in the middle of the coping length.
• One screw half way between center and each end screw.
Using a 1/8” drill bit, drill through the plastic coping and exterior pool
wall while pressing down firmly on the coping on top of pool wall.
Using a Phillips screwdriver, hand tighten each screw.
DO NOT
OVER TIGHTEN.
The beaded vinyl liner with the weight of the water will
draw coping into place and level on the interior of the
pool wall. Before installing liner, run duct tape along
the bottom lip of the coping on the pool interior
to protect liner. After the liner is in place, install
coping clips by snapping over gaps between
coping lengths.
DO NOT SCREW
IN COPING CLIPS.
For CP2 and Paver inground coping
installation instructions see on page 28.
INSTALLING PLASTIC COPING
Compression
Seam
Coping Clip
Pool Exterior
Pool Exterior
Compression
Seam
Coping Clip
Premium 4” Coping
Standard 2” Coping
SHEET METAL
SCREW
Standard
2” Coping
Premium
4” Coping
SHEET METAL
SCREW
Pool Interior
Cover bottom
lip of coping
with duct tape.
Cover bottom
lip of coping and
inside screw with
duct tape.
Pool
Interior
