Radialight KLIMA 7 AS, Руководство по эксплуатации

Страница: 26 / 128

26
it’s working. This is clearly written on the cover of the product or
shown by the symbol
❑
Do not use the product in rooms saturated with explosive gas,
vapours generated by solvents or paints or flammable vapours/gas.
❑
If the cable and/or plug are damaged, do not repair them yourself but
take the product to the technical service or a qualified repair centre
and have them repaired by specialised personnel in order to avoid
any risk of damage.
❑
Always position the product so that the plug is immediately
accessible.
❑
Never position this appliance immediately underneath a power
socket.
❑
Do not insert objects or paper into the radiator.
2. Your product
❑
Other than the heater you have chosen the package includes (picture 1):
- N° 1 metal brackets for wall mounting (fixed to the radiator);
- N° 4 nylon plug expansion 8x50mm;
-
N° 4 5x60mm cross head screws to fix wall brackets;
❑
Refer to your dealer is something is broken or missing.
3. Safe positioning
❑
Only use the product in its horizontal position;
❑
This product is fitted with a double electrical insulation circuit (class II) and therefore does not require an earth
connection;
❑
Always make observe the minimum distances from walls, furniture and/or objects, as indicated in picture 2.
❑
Never install the product on a surface made from wood or synthetic material.
❑
This product is water resistant to IP24. It may therefore be used in bathrooms or other areas subject to humidity
provided it is never installed within the perimeter of bathtubs or showers (Volume 1 of figure 2).
❑
Do not install the radiator in a draft that could disturb its regulation.
4. Installation

Remove the wall-mounting bracket fixed to the back of the radiator, by releasing first the 2 upper springs and then the
2 lower springs as shown in figure 4.

Rest the bracket on the floor to use it as a template to mark the points a which the two lower fixing holes are to be
made (figure 5A).

Lift the bracket until its lower fixing points coincide with the marks made on the wall before, and use a pencil to mark
the position of the two upper fixing points (figure 5B).

Drill the 4 holes at the points marked previously, and insert the plastic anchors (figure 6).

Fix the bracket to the wall using the 4 screws supplied (figure 7).

Hook the radiator to the bracket starting with the 2 lower fixing points, and then click the 2 upper fixing points into
position (figure 8).

Should you have to remove the radiator from the bracket at a later stage, we recommend releasing the lower two fixing
points first and then the upper fixings.
5. Electrical connections
❑
The product must be powered at a voltage of 230V AC 50Hz.
❑
The product must be supplied with a cable and plug or with a cable for installation. If a product with plug is installed in
France, connect it to the mains power supply by cutting off the plug and using a suitable connection box.
❑
If the product is supplied with a cable for installation without plug, connect it to the mains power supply using a 3-wire
cable (Brown=Live, Blue=Neutral, Black=Pilot wire) and a connection box.
If you do not wish to use the pilot wire