Radeus 8000 ACS Series, Руководство по эксплуатации и техническому обслуживанию

Страница: 170 / 174

A P P E N D I C E S
168
Series 8000™ O&M Manual
Figure 3-10 Real-time data can be displayed in the native units of HA-
DEC antennas. .................................................................................27
Figure 3-11 Setup > Receiver Specify the type of receiver being used,
if any. ...............................................................................................28
Figure 3-12 Setup > RF Inputs Note: BDC LO is only shown if the
Internal receiver type is selected on the Setup > Receiver
tab. ..................................................................................................30
Figure 3-13 Choose a meaningful on-screen label for each input. ....................31
Figure 3-14 Specify the BDC LO (“local oscillator”) frequency for ea ch
input. ...............................................................................................31
Figure 3-15 Setup > Encoders The ACU calculates the offset values.
“Position” is null if there are no encoders or resolvers. .................32
Figure 3-16 Setup > Encoders See above to enable the encoder:axis
ratio controls. ..................................................................................33
Figure 3-17 An ACU operator must confirm before the Setup Wizard
will run. ...........................................................................................36
Figure 3-18 Setup > Limits, and the Setup Wizard. See below to add
the field for setting up
sectors . .......................................................37
Figure 3-19 After enabling sectors in acu.ini, the Setup > Limits tab
allows the operator to swap between active Azimuth
sectors. ............................................................................................38
Figure 3-20 Using sector parameters allows the ACU to operate with
the correct travel limits for the current antenna sector
without the need to rediscover the limit-switch positions. ...........39
Figure 3-21 Setup > Motion Faults Settings that influence when
certain system faults will be asserted. ............................................40
Figure 3-22 Setup > Positioner ...........................................................................41
Figure 3-23 Setup > Timing See section 3.4.3, “Options” to add the
brake-control timings. .....................................................................43
Figure 4-1 The Home screen offers access to controls and system
settings without obscuring any real-time data. ..............................45