rada Safetherm, Руководство по эксплуатации продукта

Страница: 8 / 29

8
Thermostatic Shut-down
•
For safety and comfort the thermostat will shut off the thermostatic control
within 2 Seconds if either supply fails (achieved only if the blend temperature
has a minimum differential of 12°C from either supply temperature).
Connections
•
Inlets: 15 mm Compression or 1/2" BSP flat face.
•
Standard connections are: hot - left, cold - right.
•
The inlet connectors are fixed at 200 mm centres.
Important Points
1. The installation, commissioning and maintenance of this product must be
carried out in accordance with the instructions given in the manual, and must
be conducted by designated, qualified and competent personnel.
2. Installations must comply with all Local/National Water Supply Authority
Regulations/Bye-laws, and Building and Plumbing (UK:BS6700) Regulations.
3. Rada products are precision engineered and should give continued and superior
performance, provided:
a. They are installed, commissioned, operated and maintained in
accordance with these recommendations
b.
Periodic attention is given as necessary to maintain the product in
good functional order. Recommended guidelines are given in section:
‘Maintenance’ .
4. Warning! Continued use of this product in conditions outside the limits listed
in this section can severely affect the performance and reduce the effective
service life, and can present potential risk to users.
5. Suitable for use with most modulating instantaneous gas water heaters.
For information on other specific applications or suitability, contact Kohler Mira
Ltd or your local agent.
6. Disinfectants and Other Chemicals: In applications where system chemical
disinfection is practised, chlorine can be used (calculated chlorine concentration
of 50 mg/l (ppm) maximum in water, per one hour dwell time, at service interval
frequency). Such procedures must be conducted strictly in accordance with all
relevant Guidelines/Approved Codes of Practice.