13
Concealing
Shroud
6.
Turn the isolators to the
OFF
position
then turn on the water supply and
check for leaks.
Note!
The isolation valve is located
in the body of the inlet connector.
To isolate the water supply, turn the
screw slot on the isolation valve a
quarter turn.
7.
Fit the heat shrouds to the inlet
connectors.
Note!
The access
window of the heat shroud must
align with the isolation valve.
8.
Slide the concealing shrouds along
the elbows then fit the tap control
to the inlet connectors. Use a 2.5
mm hexagonal key to tighten both
grubscrews and secure the tap
control to the inlet connectors.
9.
Turn the isolators to the
ON
position
and check for leaks.
10.
Slide the concealing shroud back
and screw onto the heat shroud to
conceal the grubscrews.
11.
Set the maximum temperature
refer to section: '
Commissioning -
Maximum Temperature Setting'
.
The access window
of the heat shroud
must
align with the
isolation valve.
Heat
Shroud
OFF
ON
Содержание Safetherm
Страница 27: ...27 NOTES...
