12
2.With the frame lying on its side, attach the support leg as shown. Insert two
M8X70 hex bolts through the holes from one side, then flat washers, lock
washers and nuts from the other side. Slide the spring on the lower plunger rod.
Connect the plunger rods with a M6X25 hex bolt and nut. Hold the spring in
place by inserting a pin. Bend each side of the pin outward. Tighten down.
3.Turn the frame over and attach the axle bracket with wheels in the same
manner.
4.Make sure all bolts and nuts are tightened.
