19
Installation of the 3-tooth metal blade (for brushcutter operation)
Warning - sharp edges; wear gloves when manipulate the blade.
-
Insert a metal locking tool in the hole on the side of the drive sprocket and on the drive.
-
Remove the retaining nut, the cover bell and the plate.
-
Install in the following order, on the shaft: the blade, the plate, the cover bell and the retaining nut.
-
Remove the metal locking tool.
To remove the blade, insert a metal locking tool through the hole on the side of the drive sprocket and on
the drive shaft. Loosen the clamp nut, then remove all parts.
I
nstalling the nylon cutting head (for trimmer operation)
-
Insert a metal locking tool in the hole on the side of the drive sprocket and on the drive shaft.
-
Remove the retaining nut, the cover bell and the plate.
-
Install and screw the nylon cutting head. Make sure it is properly installed.
-
Remove the metal locking tool.
To disassemble the cutting head, insert a metal locking tool through the hole on the side of the drive
sprocket and on the drive shaft. Unscrew the cutting head to remove it.
Hedge trimmer
-
Install the bar of the main unit. Make sure the locking pin is inserted into the bar hole.
-
Fasten the bar by turning the nut counterclockwise.
