11
RaceAmerica Model 2650 Series XL Advanced
The DTSS Tree as seen from the
back bottom with post stand stored
and clamped inside. The removeable
Tree Electronics module is shown on
the right (actually left side of Tree
from the front).
Picture below shows the post
partially extended. There is an
internal stop so the post will not
come out too far. Loosen/tighten
the clamp nuts on the U-bolt (9/16 in
deep socket) at the desired position.
Four 1/4-20 wing nuts secure the
post to the base.
DTSS Tree bottom
Post extension
DTSS Tree Electronics
The DTSS Tree Electronics module can be
removed for service.
Unplug the Tree before proceeding.
Three screws hold the module - front and back
plus left side at the bottom. A #2 Phillips screw
driver will handle the job. After the screws are
removed, as the module comes out, unplug any
cables and antenna cables.
Reassemble in the reverse order
