Racal Instruments AN/TRC-207, Инструкция по эксплуатации и обслуживанию

Страница: 33 / 102

TO 31R2-2TRC207-1
3-3
3-5 PACKING.
Pack the BDR in the recommended packages illustrated in Figure 2-1. Use original packing materials if available.
3-6 HANDLING AND STORAGE.
Place electronic assemblies in individual containers. This will prevent damage during handling and storage. If a common
container is used, use suitable barrier material between electronic assemblies. Sufficient packing must be used to prevent
shifting of electronic assemblies within the container. Package the equipment in accordance with MIL-STD-2073-1A/2B.
Marking for reshipment and storage shall be in accordance with MIL-STD-129J.
Never apply pressure sensitive tape directly to connectors. This could damage connector pins.
3-6.1 Protective Measures for Electrical Connectors.
Protect all unmated connectors that are exposed to physical or environmental damage by covering with supplied protective
caps.
3-6.2 Preparation for Shipment and Storage.
Before preparing the equipment for shipment or storage, ensure that the receiver-transmitters, batteries, and any other
accessories have been removed from the bi-directional repeater.
Package all electrostatic discharge (ESD) sensitive assemblies in ESD bags before shipping or
storing.
For shipment to another facility or long-term storage, package the unit as shown in Figure 2-1. Regardless of the
electronic assembly design, fit all protruding parts with packing spacers, wrap the complete assembly with plastic or place
in a plastic air-lock bag. Wrap with a protective cellulose, foam, or similar material. Wrap assemblies that contain
electrostatic discharge sensitive (ESDS) parts in static protective materials.
3-6.3 Handling.
Following are general handling instructions which should be followed when handling the equipment.
Before performing removal/replacement procedures, make sure power is removed from the unit
by disconnecting from power source. Failure to do so could result in personal injury or equipment
damage.
Rough handling may cause unnecessary damage to electronic assemblies.
Electronic assemblies containing solid-state devices are susceptible to damage from static
electrical discharges. Wear protective clothing and grounded wrist straps.
CAUTION
CAUTION
WARNING
CAUTION
CAUTION