1260-00C User Manual
Operation 3-13
System Start-Up
Message Printing
The serial port start-up printout enable switch S21 controls
whether or not VXI system start-up messages are printed to the
serial port, as shown in Figure 3-9. The factory default
configuration disables this function
.
Figure 3-9, VXI System Start-Up Message Switch Settings
Slot 0 Resource
Manager
Configuration
To configure the 1260-00C for Slot 0 Resource Manager
operation, enable the VXIbus Slot 0 functions, and set the logical
address to 0, as shown in Table 3-7.
Table 3-7, Slot 0 Resource Manager Operation Switch and Jumper Settings
Jumper/Switch
Position
Function
Switches S9 and S15
See Table 3-8.
CLK10 routing options.
Switch S22
ON
VXI BTO enabled.
Switch S23
ON
Bus arbiter and SYSCLK enabled. CLK10
sourcing for backplane is enabled.
Switch S24
ON
MODID pulled up
Logical Address
See Chapter 5.
Logical address is 0. Set in non-volatile
configuration or use the DIP switch.
Slot 0 Model Code
See Chapter 5.
Model code is set to the Slot 0 value. Set in
non-volatile configuration.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com