Rabbit 2000, Начало работы, Страница: 24 / 43

Getting Started Manual 19
void digOut(int channel, int value)
sets the state of a digital output bit.
jrioInit must be called first.
channel is the output channel number (0-3 on the Jackrabbit).
value is the output value (0 or 1).
void digOn(int channel)
sets the state of a digital output bit to on (1).
jrioInit must be called first.
channel is the output channel number (0–3 on the Jackrabbit).
void digOff(int channel)
sets the state of a digital output bit to off (0).
jrioInit must be called first.
channel is the output channel number (0–3 on the Jackrabbit).
See the sample program
JRIOTEST.C
for an example of using the digital output functions.
4.2.3 Analog Output
The two analog output channels on the Jackrabbit (DA0 and DA1 on header J5) are con-
trolled by a pulse-width modulation (PWM) driver. This requires the use of some fraction
of the CPU cycles when the driver is running (up to 20% when both D/A channels are
used). A voltage is selected by giving a value from 0 to 1024 to the driver, corresponding
roughly to 0.1 V to 3.5 V on DA0. Because of the PWM interrupt frequency, the PWM
driver can provide a continuous range of voltage output in the range from 0.1 V to 3.0 V
for DA0, and 0.6 V to 3.6 V for DA1. These ranges can be specified with the constants
PWM_MIN
,
PWM_MAX0
, and
PWM_MAX1
. In other words, setting channel DA0 to the value
PWM_MIN
will output 0.1 V, and setting it to
PWM_MAX0
will output 3.0 V. Similarly, set-
ting DA1 to
PWM_MIN
will output 0.6 V, and setting it to
PWM_MAX1
will output 3.6 V.
Values below
PWM_MIN
will be rounded down to 0, and values above
PWM_MAX0
(
PWM_MAX1
for DA1) will be rounded up to 1024.
The output channels can also be set in an “always on” or “always off” mode, which does
not require CPU cycles. The “always on” mode is set by requesting an output value of
1024, and will provide about 3.4 V on channel DA0, and 3.6 V on DA1. The “always off”
mode is selected by asking for a value of 0, and provides an output of around 0.1 V on
DA0 and 0.0 V on DA1.