Rabbit 2000, Начало работы

Страница: 16 / 43

Getting Started Manual 11
•
A message reports that “No Rabbit processor detected” in cases where the Jackrabbit
and Prototyping Board are not connected together, the wall transformer is not con-
nected, or is not plugged in. (The red power LED lights whenever power is connected.)
•
The programming cable must be connected to the Jackrabbit board. (The colored wire
on the programming cable is closest to pin 1 on header J3 on the Jackrabbit board, as
shown in Figure 3 on page 7.) The other end of the programming cable must be con-
nected to the PC serial port, possibly, using the 9- to 25-pin adapter if necessary. The
COM port specified in the Dynamic C
Options menu must be the same as the one the
programming cable is connected to.
•
To check if you have the correct serial port, select
Compile
, then
Compile BIOS
, or
type
<ctrl-Y>
. If the “BIOS successfully compiled …” message does not display, try a
different serial port using the Dynamic C
Options
menu until you find the one you are
plugged into. Don’t change anything in this menu except the COM number. The baud
rate should be 115,200 bps and the stop bits should be 1.
3.2 Single-Stepping
Compile or re-compile
DEMOJR1.C
by clicking the
Compile
button on the task bar. The
program will compile and the screen will come up with a highlighted character (green) at
the first executable statement of the program. Use the
F8
key to single-step. Each time the
F8 key is pressed, the cursor will advance one statement. When you get to the
for(j=0,
j< ...
statement, it becomes impractical to single-step further because you would have
to press F8 thousands of times. We will use this statement to illustrate watch expressions.
3.2.1 Watch Expression
Type
<ctrl-W>
or chose
Add/Del Watch Expression
in the
Inspect
menu. A box will
come up. Type the lower case letter j and click on add to top and close. Now continue
single-stepping with
F8
. Each time you step, the watch expression (
j
) will be evaluated
and printed in the watch window. Note how the value of
j
advances when the statement
j++
is executed.
3.2.2 Break Point
Move the cursor to the start of the statement:
for(j=0; j<1000; j++);
To set a break point on this statement, type
F2
or select
Breakpoint
from the
Run
menu.
A red highlight will appear on the first character of the statement. To get the program run-
ning at full speed, type
F9
or select
Run
on the
Run
menu. The program will advance
until it hits the break point. Then the break point will start flashing and show both red and
green colors. Note that LED DS3 is now solidly turned on. This is because we have
passed the statement turning on LED DS3. Note that
j
in the watch window has the value
25000. This is because the loop above terminated when
j
reached 25000.
To remove the break point, type
F2
or select
Toggle Breakpoint
on the
Run
menu. To
continue program execution, type F9 or select Run from the Run menu. Now the LED
should be flashing again since the program is running at full speed.