Rabbit 2000, Руководство по началу работы

Страница: 26 / 54

22 Rabbit 2000 Development Kit
3.1.1 Other Sample Programs Illustrating Digital I/O
•
DEMOJR2.C
—repeatedly flashes LED DS3 (which is controlled by PA2) on the Proto-
typing Board.
This sample program also illustrates the use of the
runwatch()
function to allow
Dynamic C to update watch expressions while running. To test this:
1. Add a watch expression for "k" under "Inspect:Add/Del Watch Expression."
2. Click "Add to top" so that it will be permanently in the watch list.
3. While the program is running, type <Ctrl+U> to update the watch window.
•
DEMOJR3.C
—demonstrates the use of costatements to LED DS4 (which is controlled
by PA3) on the Prototyping Board. This sample program will also watch button S1
(PB2) and toggle LED DS1 (which is controlled by PA0) on/off when pressed. Note
that S1 presses are debounced by the software.
Parallel Port A can be set for all outputs or all inputs via the slave port control register
(SPCTR). Do not use Parallel Port A if the slave port is being used.
Bits 0–5 on Parallel Port B are always inputs, and bits 6–7 are always outputs. Do not
use Parallel Port B if the slave port is being used.
•
JRIOTEST.C
—exercises the BL1810's four digital output channels, the one analog
input channel, and the two analog output channels.
•
JRIO_COF.C
—demonstrates the use of cofunctions with the analog input driver.
Before you run this sample program, connect DA1 to AD0 on header J7 of the Proto-
typing Board to provide an input voltage. Once the sample program is running, it will
read the input voltage ten times while another costatement is executed concurrently. The
values will be printed out in the Dynamic C
STDIO window at the end of the program.
Before running the
RABDB01.C
and the
RABDB02.C
sample programs, you will need to
install 3 mm LEDs such as the Vishay Telefunken TLUR4400 at DS5–DS8 on the Jack-
rabbit Prototyping Board. These LEDs are included with the Rabbit 2000 Development Kit.
•
RABDB01.C
—flashes LEDs DS5–DS8 on the Prototyping Board (which are connected
to PA4–PA7) when corresponding switches S1–S4 (which are connected to PB2–PB5)
are pressed. The buzzer, which is driven by HV0 from PE0, will also sound whenever
switch S1 switch is pressed.
•
RABDB02.C
—flashes LEDs DS5–DS8 on the Prototyping Board (which are connected
to PA4–PA7) when corresponding switches S1–S4 (which are connected to PB2–PB5)
are pressed. The buzzer, which is driven by HV0 from PE0, will also sound whenever
switch S1 switch is pressed.
Downloaded from Elcodis.com electronic components distributor