INSTRUCTIONS
GOTCHA
®
PLUS INSTALLATION
RAB Lighting is committed to creating high-quality, aff ordable, well-designed and energy-effi cient LED lighting and controls that make it easy for electricians to install
and end users to save energy. We’d love to hear your comments. Please call the Marketing Department at 888-RAB-1000 or email: [email protected]
How Does Gotcha® Work?
The Gotcha infrared sensor “sees” small temperature changes
caused by the motion of people or cars within its Detection Zone
and turns on lights automatically. It welcomes visitors and may
deter intruders.
How long do the lights stay on?
Lights remain on as long as there is movement within the
Detection Zone. Once the zone is vacated, lights will remain on
approximately 5 sec. up to 15 min., depending on the time control
adjustment. During initial 60 sec warm-up time, lights remain on.
Will the sensor detect animals?
Gotcha may detect large animals.
You can limit animal detection by
turning down sensitivity knob or
by placing opaque weatherproof
tape on the lower part of the lens.
(
Fig 3)
OVERVIEW
GT500R KIT MOUNTING
MOUNTING TO SURFACE JUNCTION BOX
Gotcha fl oodlight kits come pre-wired and assembled on the
RAB CU4 EZ plate
, allowing for mounting on round, rectangular
or octagonal surface or recessed box.
1. Attach
Cross Bar
to
Surface Junction Box
using three bar screws
(supplied)
.
(Fig 4)
2. Bring sensor wires through the
Surface Adaptor Plate
.
3. Make connections to the supply wires in the junction box
according to the “Basic Kit Wiring” diagram on pg 5.
4. Push connected wires into the
Surface Junction box
.
5. Place the
O-Ring
over the
1/4-20 Screw
and insert into
the center of the cover plate and tighten. Use
Cap
to
cover opening.
2
Fig: 4
Fig: 3
Masking the lens
1/4-20 Screw with
O-Ring and Cap
Surface Adaptor
Plate
Cross Bar
Surface Junction Box
MOUNTING TO RECESSED JUNCTION BOX
1. Discard the
Surface Adaptor Plate
when mounting to a
Recessed Junction Box
.
2. Attach
Cross Bar
to
Junction Box
using the screws
supplied.
(Fig 5)
3. Make connections to the supply wires in the junction box
according to the
“Basic Kit Wiring” Fig 8
4. Push connected wires into
Junction Box
.
5. Place the
O-Ring
over the
1/4-20 Screw
and insert into
the center of the
Cover Plate
and tighten. Use
Cap
to
cover opening.
GT500R KIT MOUNTING
(cont’d)
GT500 SENSOR MOUNTING
Cross Bar
Recessed Junction Box
1/4-20 Screw with
O-Ring and Cap
Fig: 5
GT500 SENSOR WITH SEPARATELY PURCHASED
FLOODLIGHTS
1. Mount sensor to 1/2” NPS hole of a RAB CU4 EZ weatherproof
coverplate
(not provided)
.
(Fig 6)
2. Mount fi xtures
(not provided)
to coverplate or locate remotely.
3. Wire as shown in “Basic Wiring Diagram”
(Fig 9)
RAB CU4 EZ WEATHERPROOF COVERPLATE
Fig: 6
