14
11
4
4
12
13
8
9
10
CROSS SUPPORTS ARE NOT SHOWN
ON THIS PAGE FOR CLARITY
6703 ZINSER ST., SCHOFIELD, WI 54476
PHONE: 800.298.4351 FAX: 866.882.9475
www.raproducts.com
K&A MANUFACTURING
5
STEPS 3 & 4
3
6
7
4
2
STEPS 5 & 6
PAGE 2 OF 4
.
STEP 3:
SLIDE APART THE SECTIONS OF THE WIRE MANAGEMENT CHANNEL
5
SO THE HOLES IN THE ENDS OF THE
CHANNEL ALIGN WITH THE THREADED HOLES IN THE WELD NUTS INSIDE THE MOTOR BOXES. PLACE (4) LOCK
WASHERS
6
ON (4) SOCKET SCREWS
7
. THREAD THESE THROUGH THE HOLES IN THE ENDS OF THE WIRE
MANAGEMENT CHANNEL AND INTO THE WELD NUTS INSIDE THE MOTOR BOXES. FULLY TIGHTEN. FULLY
TIGHTEN THE (8) WOOD SCREWS
4
ATTACHING THE LEG ASSEMBLIES
2
&
3
TO THE WORKSURFACE
1
.
STEP 4:
PLACE (2) BLACK LOCK WASHERS
9
AND (2) BLACK FLAT WASHERS
8
ON (2) BLACK MACHINE SCREWS
10
. THREAD THESE THROUGH THE SLOTS IN THE OUTER WIRE MANAGEMENT SECTION AND INTO THE CAGE NUTS
ON THE INNER SECTION OF THE WIRE MANAGEMENT CHANNEL
5
. USE WHICHEVER SET OF CAGE NUTS ARE
ACCESSIBLE. FULLY TIGHTEN. ATTACH THE WIRE MANAGEMENT CHANNEL TO THE WORKSURFACE
1
USING
(5-8) WOOD SCREWS
4
.
STEP 5:
ALIGN THE HOLES IN THE HAND SWITCH
14
AND CONTROL BOX
11
WITH THE PILOT HOLES NEAR
THE FRONT OF THE WORKSURFACE
1
. ATTACH IT
WITH (2) WOOD SCREWS
4
. FULLY TIGHTEN. THE
SWITCH AND CONTROL BOX CAN BE INSTALLED IN
ANY LOCATION, WIRE LENGTHS PERMITTING.
STEP 6:
CAPTURE THE SWITCH WIRE IN THE CLAMP
12
.
ATTACH THE CLAMP WITH (1) SCREW
13
CAGE NUTS PRE-INSTALLED IN
INNER WIRE MANAGEMENT CHANNEL
VERSION DATED 2/20/14
