6703 ZINSER ST., SCHOFIELD, WI 54476
PHONE: 800.298.4351 FAX: 866.882.9475
www.raproducts.com
K&A MANUFACTURING
HAND SWITCH
HS
WE WILL REPLACE ANY DEFECTIVE PART AFTER INSPECTION BY AN AUTHORIZED AGENT. COSTS
ARE NOT COVERED UNDER THIS WARRANTY. WHEN CORRESPONDING WITH RIGHTANGLE™
(NOT SHOWN FOR CLARITY)
COLUMN
PAGE 3 OF 4
M1
OR MATERIALS AS FOLLOWS: 2 YEARS ON THE GEAR AND/OR MOTOR, INCLUDING THE CONTROL
RUN WIRES IN WIRE MANAGEMENT CHANNEL
LEFT
NewHeights™ PRODUCTS ARE WARRANTED TO BE FREE OF DEFECTS DUE TO MANUFACTURING
INCURRED DUE TO PRODUCT REPLACEMENT SUCH AS INSTALLATION LABOR OR TRANSPORTATION
PRODUCTS, RECORD AND PROVIDE THE MODEL AND SERIAL NUMBERS LOCATED ON THE CONTROL
M2
BOX.
BOX AND HAND SWITCH. 5 YEARS ON THE SUPPORT BRACKETS, ALUMINUM COLUMNS AND FEET.
WARRANTY INFORMATION:
CONTROL BOX WIRIING DIAGRAM
RESET PROCEDURE:
PRESS THE DOWN ARROW UNTIL THE WORKSURFACE REACHES ITS LOWEST
POSITION AND CLICKS. THE NewHeights™ WORKSTATION IS NOW READY FOR USE.
TROUBLESHOOTING:
IF YOU ARE HAVING ANY PROBLEMS WITH THE TABLE OPERATION, CONTACT RIGHTANGLE™
SERVICE AT 800-298-4351 OR [email protected].
STEP 7:
RUN THE CABLES AS SHOWN ON THE DIAGRAM BELOW. PLUG THE CABLES INTO THE
CONTROL BOX AS SHOWN AT LEFT.
STEP 8:
WITH THE HELP OF AN ASSISTANT, SET THE WORKSTATION UPRIGHT IN ITS FINAL LOCATION.
LEVEL THE WORKSTATION IF REQUIRED BY TURNING THE LEVELING GLIDES CLOCKWISE (FROM THE
TOP) ON THE LOW CORNERS OF THE UNIT. IF YOUR WORKSTATION HAS CASTERS, LEVEL THE UNIT
BY TURNING THE BOLTS AT THE TOP OF THE CASTERS.
VERSION DATED 2/20/14
HAND
SWITCH
RIGHT
COLUMN
RIGHT COLUMN WIRE
LEFT COLUMN WIRE
HAND SWITCH WIRE
LEVELING GLIDE
BOTTOM VIEW WIRE RUNS DIAGRAM
