10
5.2 Receiver port
5.2.1 Left side port
5.2.1.1
[1]:For frequency switch setting
Press the button more than 5 seconds, 4 lights (HDMI, LINK, WORK, MOBILE) are all turn-off,
release the key, 4 lights flash as 0.5Hz frequency, and then 4 lights back to normal state, that
means channel change is finished. If devices not connected yet after 10 seconds of frequency
switch process, please switch again. The frequency supported by device as below
:
[2]:For bind the air part and ground part.
Press the button more than 5 seconds, 4 lights (HDMI, LINK, WORK, MOBILE) are all turn-off,
then stop press the button, 4 lights flash one by one, when the LED light works well that means
they are well binded.This may takes 2 minutes.If the connection has not been resumed after 2
minutes, repower on both ends, and do not need to rebind.
[3]: Monitor the receiver work status.
Light status
Description
Action
Flash
regularly
Receiver works well
NA
Other status Receiver does not work well
Connect the power again or
contact with the customer
service
[4]: Monitor Transmitter and receiver connect status.
Light status
Description
Action
Turn-on
Connect with Transmitter
NA
Turn-off
Des not connect with Transmitter
1. Please wait for connecting
2. Make sure the Transmitter
is connecting the power.
3. Bind the Transmitter and
receiver again.
4. Connect the power again
[5]: monitor the display device status.
Light status
Description
Action
Turn-on
Display device connect well
NA
Turn-off
Display device does not connect
Check Display device cable